Cub Cadet SLTX1000 Series - Manual (Page 137)

CVT DRIVE AND BRAKE SYSTEM
131
6d. Inspect the brake shaft and inner brake pad.
NOTE: The inner pad is epoxied in-place, but may be
pried-out for replacement.
6e. Disassemble and inspect the brake yoke.
See Figure 6.91.
7. Remove the 13 remaining perimeter screws that hold
the upper transaxle housing to the lower transaxle
housing using a 3/8” wrench.
8. Separate the two housings. See Figure 6.92.
NOTE: The axle shafts will generally be of different
lengths. Mark, or note the orientation of the differ-
ential and axle assembly to the transaxle housing
before removing it.
9. Lift the axle and differential housing out of the tran-
saxle. See Figure 6.93.
10. Note the positions of the shim washers.
Figure 6.91
Brake arm
Brake yoke
Brake pins
Backing plate
Brake pad
Figure 6.92
Lower housing
Upper housing
Figure 6.93
Shims