Sync – Thermcraft XST-6-0-36-3V User Manual
Page 99
Installation and Operation Handbook
Programmer Operation
2408 and 2404 Controller
5-15
Event output 1
(16-segment programmers only)
Appears in all segments, except ‘
cALL’ segments.
Use
or
to set output 1:
•
OFF
:
Off in the current segment
•
on
:
On the current segment.
Press
Further event outputs
(16-segment programmers only)
Up to eight (8) event outputs may appear in this list where ‘n’ =
event number.
Pressing
will step through all the remaining event outputs.
Note: If you are not using all of the event outputs, you can step
immediately to the next segment number by pressing
.
Press
Synchronisation event output (only appears if configured)
Use
or
to select:
•
YES
: Synchronisation
Enabled
•
no
: Synchronisation
Disabled
Note: This event output, if used, occupies the position of ‘
out8’.
Press
End segment
Use
or
to select:
•
dwEl
:
An indefinite dwell
•
rSEt
: Reset.
•
S OP
:
End Segment Output Power Level
Press
SYnc
YES