Thermcraft XST-6-0-36-3V - Manual (Page 228)

Programmer Operation Installation and Operation Handbook
5-10 2416 Controller
CREATING A NEW PROGRAM OR MODIFYING AN EXISTING ONE
The only difference between creating a new program and modifying an existing one, is that a
new program starts with all its segments set to ‘
End’ in the ‘tYPE’ parameter. The procedure
for both consists of setting up the parameters in the ‘
ProG’ list of the Operation Navigation
Diagram shown in Chapter 2. As explained earlier, under ‘Programmer States’, temporary
changes can be made to these parameters while in the HOLD state, but permanent changes (to
the stored values) can only be made when the programmer is in the Reset state. So, before
modifying a stored program first make sure that it is in Reset and then follow the procedure
below:
Program edit list
From the Home display press until you reach the ‘
ProG
LiSt’ header.
Press
Program number
This display only appears on the four-program controllers.
Use
or to select the number of the program which you
wish to modify (from 1 to 4).
Press
Holdback type
[Only appears when Holdback has been selected for the whole
program.]
Use
or to select:
• OFF Holdback disabled
• Lo Deviation Low Holdback
• Hi Deviation High Holdback.
• bAnd Deviation Band Holdback
Press
Holdback value
Use
or to set a value.
Press
(Continued on the next page.)
prog
List
prog
1
Hb
band
Hb V
5.0