Thermcraft XST-6-0-36-3V - Manual (Page 93)

Installation and Operation Handbook Programmer Operation
2408 and 2404 Controller 5-9
Power fail strategy
Use
or to select
• cont : Continue from last setpoint
• rmP.b : Ramp from PV to setpoint at last ramp rate
• rSEt: Reset the program.
Press
Servo type
Use
or to select:
• to.PV : Servo to PV
• to.SP : Servo to SP
Press
Event Outputs (not in 8-segment programmer)
Use or to select:
• no : Event outputs disabled
• YES : Event outputs enabled
Press
Synchronisation (not in 8-segment programmer)
Use
or to select:
• no : Synchronisation disabled
• YES : Synchronisation enabled
Press to return the list header.