Thermcraft XST-6-0-36-3V - Manual (Page 57)

Operation Installation and Operation Handbook
2408 and 2404 Controller 2-7
MANUAL MODE
If the AUTO light is on, press the AUTO/MAN button to select manual mode. The MAN
light comes on.
Power
on
x 2
The Home display
Check that the MAN light is on.
The upper readout shows the measured temperature, or
process value. The lower readout shows the % output.
To adjust the output, press
or .
(Note: If Output Rate Limit has been enabled, then the
lower readout will show the working output. If
or
is pressed, it will change to show and allow adjustment of,
the target output.)
Press once.
Display units
A single press of
flashes the display units for 0.5
seconds, after which you are returned to the Home display.
Flashing of the display units may have been disabled in
configuration, in which case a single press will take you
straight to the display shown below.
Press twice.
Setpoint
To adjust the setpoint value, press
or .
Press .
Pressing from the Output Power display may access further parameters. These may be in
this scroll list if the ‘Promote’ feature has been used (see Chapter 3, Edit Level). When you
reach the end of this scroll list, pressing
will return you to the Home display.