Thermcraft XST-6-0-36-3V - Manual (Page 159)

Installation and Operation Handbook Load Current Monitoring and Diagnostics
2408 and 2404 Controller D-11
TO ATTACH SOFT ALARMS TO A RELAY OUTPUT
Any one alarm indicated above may be attached to an output (normally a relay). Alternatively
any combination of alarms may be attached to operate a relay using the procedure below:-
Do This This Is The Display You Should See Additional Notes
Press “PAGE” key
as many times
as necessary to AA
ConF
Press
until
1--- is displayed
Press
or
to select YES or
Repeat the above
step for every alarm
to be attached to the
output
To select the output
which you want to
operate when the
alarm condition
occurs.
You may also
choose 1A, 1B, 1C,
2A, 2B, 2C, 3A, 3B,
3C or 4A depending
upon the controller
and the number and
type of modules
fitted
yes means that the
selected output will
activate when an
alarm occurs in
normal operation
no means the
output will not
activate
aA
Conf
1---
yes
1---- denotes alarm 1
followed by three letters
which denote the alarm
type e.g.
LCr
Alarms Connected to a
Relay Output
dIG
SEnS
nor
inv Output
Module
Soft
Alarms
OR
AA
AB