Thermcraft XST-6-0-36-3V - Manual (Page 109)

Installation and Operation Handbook Configuration
2408 and 2404 Controller 6-9
Name Description Values Meaning
iP Input configuration
inPt Input type J.tc J thermocouple
k.tc K thermocouple
L.tc L thermocouple
r.tc R thermocouple (Pt/Pt13%Rh)
b.tc B thermocouple (Pt30%Rh/Pt6%Rh)
n.tc N thermocouple
t.tc T thermocouple
S.tc S thermocouple (Pt/Pt10%Rh)
PL 2 PL 2 thermocouple
C.tc Custom downloaded t/c (default = type C)
rtd 100 Ω platinum resistance thermometer
mV Linear millivolt
voLt Linear voltage
mA Linear milliamps
Sr V Square root volts
Sr A Square root milliamps
* see CUST List. mV.C 8-point millivolt custom linearisation *
V.C 8-point Voltage custom linearisation *
mA.C 8-point milliamp custom linearisation *
CJC Cold Junction Auto Automatic internal compensation
Compensation 0 o C 0 o C external reference
45 o C 45 o C external reference
50 o C 50 o C external reference
OFF No cold junction compensation
imp Sensor Break Impedance Off Disabled (applies to any input)
Caution:
If sensor break is disabled the
controller will not detect open circuit
faults
Auto Factory set (Default i.e. enabled)
Hi Impedance of input > 5K Ω
Hi.Hi Impedance of input > 15K Ω
Linear Input Scaling − The next 4 parameters only appear if a linear or sq rt input is chosen.
inp.L Input value low
inp.H Input value high
VAL.L Displayed reading low
VAL.H Displayed reading high
inP.H inP.L
VAL. H
Displayed Value
VAL. L
Electrical
Input