Thermcraft XST-6-0-36-3V - Manual (Page 205)

Installation and Operation Handbook Access Levels
2416 Controller 3-1
3 Chapter 3 ACCESS LEVELS
This chapter describes the different levels of access to the operating parameters within the
controller.
There are three topics:
• THE DIFFERENT ACCESS LEVELS
• SELECTING AN ACCESS LEVEL
• EDIT
LEVEL
THE DIFFERENT ACCESS LEVELS
There are four access levels:
• Operator level, which you will normally use to operate the controller.
• Full level, which is used to commission the controller.
• Edit level, which is used to set up the parameters that you want an operator to be able to
see and adjust when in Operator level.
• Configuration level, which is used to set up the fundamental characteristics of the
controller.
Access
level
Display
shows
What you can do Password
Protection
Operator OPEr In this level, operators can view and adjust the
value of parameters defined in Edit level (see
below). No
Full FuLL In this level, all the parameters relevant to a
particular configuration are visible. All alterable
parameters may be adjusted. Yes
Edit Edit In this level, you can determine which
parameters an operator is able to view and
adjust in Operator level. You can hide, or
reveal, complete lists, individual parameters
within each list and you can make parameters
read-only or alterable. (See Edit level at the
end of this chapter). Yes
Configuration conF This special level allows access to set up the
fundamental characteristics of the controller. Yes
Figure 3-1 Access levels