Thermcraft XST-6-0-36-3V - Manual (Page 66)

Operation Installation and Operation Handbook
2-16 2408 and 2404 Controller
Name Description
oP Output list
Does not appear if Motorised Valve control
configured.
OP.Lo
Low power limit (%)
OP.Hi High power limit (%)
OPrr Output Rate Limit (% per sec)
FOP Forced output level (%)
CYC.H Heat cycle time (0.2S to 999.9S)
hYS.H Heat hysteresis (display units)
ont.H Heat output min. on-time (secs)
Auto (0.05S), or 0.1 - 999.9S
CYC.C Cool cycle time (0.2S to 999.9S)
hYS.C Cool hysteresis (display units)
ont.C Cool output min. on-time (secs)
Auto (0.05S), or 0.1 - 999.9S
HC.db Heat/cool deadband (display
units)
End.p To set power level in end
segment
Sb.OP Sensor Break Output Power (%)
cmS Comms list
Addr Communications Address
cmS DeviceNet (additional
parameters)
Nw.St Indicates network status
run Network connected and
operational
rdy Network connected but not
operational
oFF.L Network not connected
inFo Information list
diSP Configure lower readout of Home
display to show:
VPoS Valve position
Std Standard - display setpoint
AmPS Load current in amps
OP Output
Stat Program status
PrG.t Program time remaining in
hours
Li 2 Process value 2
rAt Ratio setpoint
PrG Selected program number
rSP Remote setpoint
LoG.L PV minimum
LoG.H PV maximum
LoG.A PV mean value
Log.t Time PV above Threshold level
Log.v PV Threshold for Timer Log
Continued in next column
Name Description
inFo Information list - continued
rES.L Logging Reset - ‘YES/no’
The following set of parameters is for
diagnostic purposes.
w.OP Working output
FF.OP Feedforward component of output
VO PID output to motorised valve
ACCS Access List
codE Access password
Goto Goto level - OPEr, FuLL, Edit or
conF
ConF Configuration password