Thermcraft XST-6-0-36-3V - Manual (Page 235)

Installation and Operation Handbook Configuration
2416 Controller 6-3
6.2 SELECTING A CONFIGURATION PARAMETER
The configuration parameters are arranged in lists as shown in the navigation diagram in
Figure 6.1.
To step through the list headers, press the Page button.
To step through the parameters within a particular list press the Scroll button.
When you reach the end of the list you will return to the list header.
You can return directly to the list header at any time by pressing the Page button.
6.2.1 Parameter names
Each box in the navigation diagram shows the display for a particular parameter. The upper
readout shows the name of the parameter and the lower readout its value. For a definition of
each parameter, see the Configuration Parameter Tables at the end of this chapter. To change
the value of a selected parameter, use the and buttons.
The navigation diagram shows all the lists headers and parameters that can, potentially, be
present in the controller. In practice, those actually present will vary according to the
particular configuration choices you make.
6.3 CHANGING THE PASSWORDS
There are TWO passwords. These are stored in the Password configuration list and can be
selected and changed in the same manner as any other configuration parameter.
The password names are:
‘
ACC.P’ which protects access to Full level and Edit level
‘
cnF.P’
which protects access to Configuration level.
6.4 LEAVING CONFIGURATION LEVEL
To leave the Configuration level and return to Operator level Press until the ‘
Exit’
display appears.
Alternatively, pressing and together will take you directly to the ‘
Exit’ display.
Use or to select ‘
YES’. After a two-second
delay, the display will blank then revert to the Home
display in Operator level.
Exit
no