Func, Baud – Thermcraft XST-6-0-36-3V User Manual
Page 124
Configuration
Installation and Operation Handbook
6-24
2408 and 2404 Controller
DeviceNet
To configure Function, Baud Rate, Resolution and Node Address:-
Do This
The Display You Should
See
Additional Notes
1. Press
as many
times as necessary to
select ‘
HA’
This is the position in which
the DeviceNet module is
fitted
2. Press
to read ‘
id’
If the module is present
id = ‘cms’ (digital
communications) or ‘
none’ if
the module is not present
3. Press
to read
‘
Func’
If the DeviceNet module is
fitted ‘
Func’ = ‘dnEt’ and
will be read only
4. Press
to read
‘
bAud’
5. Press
and
to
select the baud rate
Baud rate can be set to
125(K), 250(K) or 500(K)
6. Press
to read
‘
rES’
7. Press
and
to
select ‘
FuLL’ or ‘int’
FuLL - the decimal point
position is implied, eg 100.1
is transmitted as 1001.
‘
int’ - rounded to the
nearest integer value
HA
ConF
id
cms
Func
dnEt
bAud
500
res
FuLL