Thermcraft XST-6-0-36-3V - Manual (Page 223)

Installation and Operation Handbook Programmer Operation
2416 Controller 5-5
RUNNING A PROGRAM FROM THE RUN LIST
The Run List
From the Home display, press until you reach the ‘
run’ list
header.
Press
Program number
This display will only appear on controllers that can hold more
than one program (Models 2416/P4 & 2416/V4). Use or
to select the required program number, from 1 to 4.
Press
Status selection
Use or to select:
• run
Run program.
• hoLd Hold
program.
• OFF
Program reset.
After two seconds, the lower readout blinks and the chosen state is
now active.
To return to the Home display press and together.
Other parameters
To access the other parameters in the ‘
run’ list, continue to press
. These parameters are shown in the ‘Program run list’ in
Chapter 2, Parameter Tables. They show the current status of the
active program.
Temporary changes
Temporary changes can be made to the parameters in this ‘
run’ list, (for example a setpoint,
ramp rate, or an unelapsed time), by first placing the programmer into ‘
hoLd’. Such changes
will remain active only for the duration of the segment; the segment parameters will revert to
their original (stored) values whenever the segment is re-executed.
run
List
prg
1
stat
Off