Thermcraft XST-6-0-36-3V - Manual (Page 141)

Installation and Operation Handbook Safety Information
2408 and 2404 Controller B-1
SAFETY and EMC INFORMATION
This controller is manufactured in the UK by Eurotherm Ltd.
Please read this section carefully before installing the controller
This controller is intended for industrial temperature and process control applications when it
will meet the requirements of the European Directives on Safety and EMC. Use in other
applications, or failure to observe the installation instructions of this handbook may impair
the safety or EMC protection provided by the controller. It is the responsibility of the
installer to ensure the safety and EMC of any particular installation.
GENERAL
The information contained in this manual is subject to change without notice. While every
effort has been made to ensure the accuracy of the information, your supplier shall not be held
liable for errors contained herein.
Safety
This controller complies with the European Low Voltage Directive 73/23/EEC, by the
application of the safety standard EN 61010.
Electromagnetic compatibility
This controller conforms with the essential protection requirements of the EMC Directive
89/336/EEC, by the application of appropriate product specific international standards.
This instrument satisfies the general requirements of the commercial and industrial
environments defined in EN 61326. For more information on product compliance refer to
the Technical Construction File.
Unpacking and storage
The packaging should contain an instrument mounted in its sleeve, two mounting brackets for
panel installation and an Installation & Operating guide. Certain ranges are supplied with an
input adapter.
If on receipt, the packaging or the instrument are damaged, do not install the product but
contact your supplier. If the instrument is to be stored before use, protect from humidity and
dust in an ambient temperature range of -20
o C to +70 o C.
SERVICE AND REPAIR
This controller has no user serviceable parts. Contact your nearest Eurotherm agent for
repair.
Caution: Charged capacitors
Before removing an instrument from its sleeve, disconnect the supply and wait at least two
minutes to allow capacitors to discharge. Failure to observe this precaution will expose
capacitors that may be charged with hazardous voltages. In any case, avoid touching the
exposed electronics of an instrument when withdrawing it from the sleeve.