Thermcraft XST-6-0-36-3V - Manual (Page 219)

Installation and Operation Handbook Programmer Operation
2416 Controller 5-1
5 Chapter 5 PROGRAMMER OPERATION
This chapter deals with the setpoint programming option. All 2416 instruments have a basic
8-segment programmer built-in as standard. This facility must be enabled by the user, as
explained in the section, Configuring the Programmer.
Other programmer versions are listed below, and have 16-segments in each program.
Standard controller with:
a single program:
Model 2416/CP.
four stored programs:
Model 2416/P4.
Motorised valve controller with:
a single program:
Model 2416/VP.
four stored programs:
Model 2416/V4.
The 8-segment programmer differs from the other programmers in that it will not provide
event outputs. Otherwise they all operate in the same way.
There are seven topics:
• WHAT IS SETPOINT PROGRAMMING?
• PROGRAMMER
STATES
• RUNNING A PROGRAM FROM THE RUN LIST
• RUNNING A PROGRAM USING THE RUN/HOLD BUTTON
• AUTOMATIC
BEHAVIOUR
• CONFIGURING THE PROGRAMMER
• CREATING A NEW PROGRAM, OR MODIFYING AN EXISTING PROGRAM.
To understand how to select and change parameters in this chapter you will need to have read
Chapter 2, Operation and Chapter 3, Access Levels.