Thermcraft XST-6-0-36-3V - Manual (Page 243)

Installation and Operation Handbook Configuration
2416 Controller 6-11
Name Description Values Meaning
For ‘
id’ = ‘cms’ use this parameter table:
Func Function mod Modbus protocol
EI.bi Eurotherm Bisynch protocol
bAud Baud Rate 1200, 2400, 4800, 9600, 19.20(19,200)
dELy no No delay Delay - quiet period, required
by some comms adaptors YES Delay active - 10mS
The following parameters only appear if the function chosen is Modbus protocol.
Prty
Comms Parity nonE No parity
EvEn Even parity
Odd Odd parity
rES Comms Resolution FuLL Full resolution
Int Integer resolution
dELy no No delay Delay - quiet period, required
by some comms adaptors YES Delay active - 10mS
For ‘
id’ = ‘pds’ use this parameter table:
Func Function nonE No PDSIO function
SP.oP PDSIO setpoint retransmission
PV.oP PDSIO PV retransmission
Er.OP PDSIO error signal retransmission
OP.oP PDSIO output power retransmission
VAL.L Retransmitted Value Low
VAL.H Retransmitted Value High
For ‘
id’ = ‘Pdsi’ use this parameter table:
Func Function SP.iP PDSIO setpoint input
VAL.L Setpoint Displayed Value - Low
VAL.H Setpoint Displayed Value - High
VAL.L
100% 0%
VAL.H
Displayed Value
Retransmitted
Output
VAL.L
100% 0%
VAL.H
Displayed Value
Electrical Input