Thermcraft XST-6-0-36-3V - Manual (Page 238)

Configuration Installation and Operation Handbook
6-6 2416 Controller
6.6 CONFIGURATION PARAMETER TABLES
Name Description Values Meaning
inSt Instrument configuration
CtrL Control type Pid PID control
On.OF On/off control
VP Boundless motorised valve
control - no feedback required
Act Control action rEv Reverse acting
dir Direct acting
CooL Type of cooling Lin Linear
oiL Oil (50mS minimum on-time)
H2O Water (non-linear)
FAn Fan (0.5S minimum on-time)
on.OF On/off cooling
ti.td Integral & derivative SEc Seconds, OFF to 9999
time units min Minutes, OFF to 999.9
dtYP Derivative type PV
Err
Operates on rate of change of
PV
Operates on rate of change of
error
m-A Front panel Auto/Man button EnAb Enabled
diSA Disabled
r-h Front panel Run/Hold button EnAb Enabled
diSA Disabled
PwrF Power feedback on On
OFF Off
Fwd.t Feed forward type none None
FEEd Normal feed forward
SP.FF Setpoint feed forward
PV.FF PV feed forward
Pd.tr Manual/Auto transfer when no Non-bumpless transfer
using PD control YES Bumpless transfer - (Pre-loads
Manual Reset value)
Sbr.t Sensor break output Sb.OP Go to pre-set value
HoLd Freeze output
FOP Forced manual output no Bumpless Auto/Manual transfer
trac Returns to the Manual value
that was set when last in
Manual mode
Step Steps to forced output level.
Value set in ‘
FOP’ of ‘op-List’
in Operator Level
bcd BCD input function nonE Not used
ProG
SP
Only functional in Models 2408
& 2404. Set ‘
bcd
’ to ‘
none
Select setpoint number
Gsch Gain Schedule Enable no Disabled
YES Enabled