Thermcraft XST-6-0-36-3V - Manual (Page 96)

Programmer Operation Installation and Operation Handbook
5-12 2408 and 2404 Controller
Ramp units
Use
or to select:
• Sec
• min
• Hour
Press
Dwell units
Use
or to select:
• Sec
• min
• Hour
Press
Number of program cycles
Use
or to set the number of program cycles required from
1 to 999, or ‘cont’ for continuous cycling.
Press
Segment number
Use
or to select the number, from 1 to 16.
(1 to 8 in 8-segment programmers)
The parameters that follow ‘
SEG.n’ set up the characteristics of
the individually-selected segment number. By defining the
characteristics of each segment of the program, you define the
whole program.
Press
Continued on the next page.