Thermcraft XST-6-0-36-3V - Manual (Page 246)

Configuration Installation and Operation Handbook
6-14 2416 Controller
Name Description Values Meaning
For ‘
id’ = ‘dC.OP’, use this parameter table:
Func Function nonE Function disabled
HEAt Heating output
COOL Cooling output
PV Retransmission of PV
wSP Retransmission of setpoint
Err Retransmission of error signal
OP Retransmission of OP power
VAL.L % PID, or Retrans’n Value,
giving minimum output
VAL.H % PID, or Retrans’n Value,
giving maximum output
unit voLt = Volts, mA = milliamps
Out.L Minimum electrical output
Out.H Maximum electrical output
2A Module 2 configuration
As per module 1 configuration, but excluding the ‘ SSr.1’, ‘SSr.2’ options on a logic output.
3A Module 3 configuration
As per module 2 configuration.
Cust
8-point Custom Linearisation
(1)
in 1
Custom input 1
VAL.1
Linearisation Value representing
in 1
in 8
Custom input 8
VAL.8
Linearisation Value representing
in 8
VAL.L
Out.H Out.L
VAL.H
Electrical
Output
%PID, or Retransmission Value
Note:
1. Custom Linearisation is only available when ‘
ip- ConF list has ‘inpt’ set to
‘
mV.C’, or ‘mA.C’, or ‘V.C’
2. Custom curves must be continuously increasing or decreasing in value and input.
VAL.1
VAL.3
in 8 in 1 in 3
VAL.8
Displayed Value
Electrical
Input