Thermcraft XST-6-0-36-3V - Manual (Page 62)

Operation Installation and Operation Handbook
2-12 2408 and 2404 Controller
PARAMETER TABLES
Name Description
Home list
Home Measured value and Setpoint
OP % Output level
SP Target setpoint (if in Manual mode )
m-A Auto-man select
AmPS Heater current (With PDSIO mode 2)
C.id Customer defined identification number
+ Extra parameters, if the ‘Promote’ feature has been used (see Chapter 3, Edit Level).
run Program run list − Present only in setpoint programming controllers
PrG Active program number (Only on 4, or 20, program versions)
StAt Program status ( OFF, run, hoLd, HbAc, End)
PSP Programmer setpoint
CYC Number of cycles remaining in the program
SEG Active segment number
StyP Active segment type
SEG.t Segment time remaining in the segment units
tGt Target setpoint
rAtE Ramp rate (if a rate segment)
PrG.t Program time remaining in hours
FASt Fast run through program ( no / YES)
out.n Event output states ( OFF / on) (not 8-segment programmer)
SYnc Segment synchronisation ( no / YES) (not 8-segment programmer)
SEG.d Flash active segment type in the lower readout of the home display ( no / YES)