Thermcraft XST-6-0-36-3V - Manual (Page 229)

Installation and Operation Handbook Programmer Operation
2416 Controller 5-11
Ramp units
Use or to select:
• SEc
• min
• Hour
Press
Dwell units
Use or to select:
• SEc
• min
• Hour
Press
Number of program cycles
Use or to set the number of program cycles required from
1 to 999, or ‘cont’ for continuous cycling.
Press
Segment number
Use or to select the number, [1 to 8 ( 8-seg programmer )], or
1 to 16.
The parameters that follow ‘
SEG.n’ set up the characteristics of
the individually-selected segment number. By defining the
characteristics of each segment of the program, you define the
whole program.
Press
Continued on the next page.
SEG.n
1
rmp.V
min
DwL.U
min
CYC.n
1