Metrohm 799 GPT Titrino - Manual (Page 18)

2.5 Selection of the mode, key
799 GPT Titrino
14
2.5 Selection of the mode, key
Press key until the desired mode is
displayed and confirm with .
Select the measured quantity pH, U, Ipol, Upol, (T) with
<←> or <→> and confirm it also with .
The following modes can be selected:
• DET: Dynamic Equivalence-point Titration
• MET: Monotonic Equivalence-point Titration
• SET: Set Endpoint Titration.
• KFT: Karl Fischer Titration, the determination of
water content.
• STAT: Keeping a measured value constant, i.e. pH-
STAT.
• DOS: Dosing function with volume, time, or rate
control.
• DOC: Dosing Controlled by a measured value
gradient.
• CAL: pH Calibration.
• MEAS: Measuring.
• TIP: Titration Procedure. Linking of various
commands and methods to a titration procedure.
These standard modes are equipped with a set of
standard parameters. They only need few settings in
order to be ready to work.
TIP is an empty "shell". The TIP sequence has to be
defined with , see page 85.
You will find a survey of the modes in the short
Instructions for use.
MODE
;
–
mode
mode: DET
measured quantity: pH