Metrohm 799 GPT Titrino - Manual (Page 149)

3.2 Remote control commands
799 GPT Titrino
145
3.2.2.10. Mode.Def.TempVar.C70 RSX, EPX, CXX
etc. up to .C79
Assignment of temporary variables in a submethod for calculations in TIP.
3.2.2.11. Mode.CFmla
Mode.CFmla.1.Value 0...±999 999
Mode.CFmla.2.Value
etc., up to .19
Calculation constants specific to a method. Stored in the method memory of
the Titrino. Operands specific to the sample (3.2.2.117 and 3.2.2.135) and
values of common variables (3.2.2.109) on the other hand are not stored with
the methods.
3.2.2.12. Mode.Parameter.TitrPara.MptDensity 0...4...9
Mode.Parameter.TitrPara.MinIncr 0...10.0...999.9
Mode.Parameter.TitrPara.VStep 0...0.10...9.999
.MptDensity: Parameter for DET: Measuring point density.
.MinIncr: Parameter for DET: Minimum increment in uL. If the minimum in-
crement is set to 0, measured values are stored vs. time.
.VStep: Parameter for MET: Volume increment in mL. With "0", there is no
dispensing and measured values vs. time are entered in the
measuring point list.
3.2.2.13. Mode
. Parameter.TitrPara.DosRate 0.01...150, max.
Parameters for DET and MET: Dispensing rate for the volume increments in
mL/min. Max. means maximum possible dispensing rate with the Exchange
Unit in current use.
3.2.2.14. Mode.Parameter.TitrPara.SignalDrift pH,U,Ipol:0.5...50...999, OFF
Upol: 0.05...50...99.9, OFF
Mode.Parameter.TitrPara.UnitSigDrift read only
Mode.Parameter.TitrPara.EquTime 0...26...9999, OFF
Parameters for DET and MET: Criteria for the measured value acquisition.
Measured value drift in mV/min (with pH, U, Ipol) or uA/min (with Upol),
equilibration time in s. OFF means that the corresponding criterion is switched
off. If both criteria are OFF, the measured values are acquired immediately af-
ter dispensing.
If the equilibration time has never been edited, it is automatically calculated by
the instrument to match the drift, see page 20. After it has been edited once, it
remains in force with the set value.
3.2.2.15. Mode.Parameter.TitrPara.StartV.Type abs., rel., OFF
Mode.Parameter.TitrPara.StartV.V 0...999.99
Mode.Parameter.TitrPara.StartV.Factor 0...±999 999
Mode.Parameter.TitrPara.StartV.Rate 0.01...150, max.
Parameters for DET, MET, SET, KFT, STAT: Start volume.
If an absolute start volume (abs.) has been selected, the volume in mL is
valid.