Metrohm 799 GPT Titrino - Manual (Page 154)

3.2. Remote control commands
799 GPT Titrino
150
Parameter for SET, KFT, STAT: Time interval in s for the entry of a measure-
ment point in the list of measured points.
3.2.2.36. Mode.Parameter.Presel.Cond ON, OFF
Mode.Parameter.Presel.DriftDisp ON, OFF
Mode.Parameter.Presel.DCor.Type auto, man., OFF
Mode.Parameter.Presel.DCor.Value 0.0...99.9
Parameters for SET, KFT:
.Cond: Conditioning ON/OFF
.DriftDisp: Drift display during conditioning ON/OFF.
.DCor.Type: Type of drift take-over for the drift correction. auto: Take-over of
the drift value at start.
.DCor.Value: Drift value for the manual drift correction.
3.2.2.37. Mode.Parameter.CtrlPara.EP pH:
0...±20.00, OFF
U, Ipol: 0...±2000, OFF
Upol: 0...±200.0, OFF
Mode.Parameter.CtrlPara.UnitEp read only
Parameters for KFT, STAT: Setting of the EP, resp. Control point as a pH
value, in mV (with U and Ipol) or uA (with Upol). The corresponding unit can
be read with .UnitEP.
With KFT the standard value for Ipol is 250 mV, for Upol 25 uA.
3.2.2.38. Mode.Parameter.CtrlPara.Dyn pH: 0.01...20.00, OFF
U, Ipol: 1...2000, OFF
Upol: 0.1...200.0, OFF
Mode.Parameter.CtrlPara.UnitDyn read only
Mode.Parameter.CtrlPara.MaxRate 0.01...10...150, max.
Mode.Parameter.CtrlPara.MinIncr 0.1...9.9, min.
Parameters for KFT, STAT: Control parameters.
.Dyn: Dynamics (control range) in pH, mV (with U and Ipol) or uA (with Upol).
The corresponding unit can be read with .UnitDyn. Standard with
KFT Ipol 100, with KFT Upol 10.
.MaxRate: Maximum allowed titration rate in ml/min. Max. means maximum
possible rate with mounted Exchange Unit.
.MinIncr: Parameter for KFT. Minimum volume increment in ul.
3.2.2.39. Mode.Parameter.Presel.Oven COM1, COM2, no
Parameter for KFT.
If an Oven is connected, its results will be incorporated into the result report of
the Titrino.
If there is no Oven connected via RS232, this parameter has to be on "no".
3.2.2.40. Mode.Parameter.CtrlPara.MinRate 0.01...25.0...9999
Parameter for STAT: Control parameters.
.MinRate: Minimum titration rate in ul/min.