Metrohm 799 GPT Titrino - Manual (Page 129)

3.2 Remote control commands
799 GPT Titrino
125
*Parameter Tree part "Parameters for DOS, monitoring", continuation
├ . Monitoring Monitoring
│ ├ .Temp Monitoring of temperatures
│ │ ├ .Status Status ON, OFF 3.2.2.47.
│ │ ├ .LowLim Lower limit -170.0...500.0 ditto
│ │ ├ .UpLim Upper limit -170.0...500.0 ditto
│ │ ├ .Action Action if out of limits end, hold, wait, none ditto
│ ├ .L10Output Assignment of output L10
│ │ ├ .AssignOutput To type of limit violation meas,temp,all,none 3.2.2.48.
│ │ ├ .Limit Assign output to violated limit upper, lower, any ditto
│ │ ├ .Output Signal to be set on output L10 active, pulse ditto
│ ├ .L11Output as for output L10
│ ├ .L12Output as for output L10
│ ├ .L13Output as for output L10
│ │
├
. Presel Preselections
│ ├ .IReq Request of Id's after start id1, id1&2, all, OFF 3.2.2.26.
│ ├ .SReq Request of smpl size after start value, unit, all, OFF ditto
│ ├ .LimSmplSize Limits for sample size 3.2.2.27
│ │ ├ .Status Status of limit control ON, OFF ditto
│ │ ├ .LoLim Lower limit 0.0...999 999 ditto
│ │ ├ .UpLim Upper limit 0.0...999 999 ditto
│ ├ .ActPulse Output of a pulse ON, OFF 3.2.2.28.