Metrohm 799 GPT Titrino - Manual (Page 156)

3.2. Remote control commands
799 GPT Titrino
152
3.2.2.47. Mode.Parameter.Monitoring.MeasVal.Status ON, OFF
Mode.Parameter.Monitoring.MeasVal.LowLim pH: 0...±20.00
Mode.Parameter.Monitoring.MeasVal.UpLim U, Ipol: 0...±2000
Upol: 0...±200.0
Mode.Parameter.Monitoring.MeasVal.Action end, hold, wait, none
Parameters for STAT, DOC: Monitoring of limit values. Measured values (pH,
U or I) are entered in the list of measured points only if the monitoring is ac-
tive.
On limit value violation, an action can be selected:
end: Abort of the determination.
hold: Interrupt dosing until the sequence is continued by manual switching
(&m $C).
wait: Interrupt dosing until the limit value is no longer violated, then continue
automatically.
3.2.2.48. Mode.Parameter.Monitoring.Rate.Status ON, OFF
Mode.Parameter.Monitoring.Rate.LowLim 0.000...150
Mode.Parameter.Monitoring.Rate.UpLim 0.000...150
Mode.Parameter.Monitoring.Rate.Action end, hold, wait, none
Parameters for STAT: Monitoring of limit values of the rate. Entry in ml/min.
On limit value violation, an action can be selected:
end: Abort of the determination.
hold: Interrupt dosing until the sequence is continued by manual
switching (& m $C).
wait: Interrupt dosing until the limit value is no longer violated, then
continue automatically. On violation of the lower limit, the se-
quence can no longer be continued as the rate would become
even less than that when dosing was interrupted.
3.2.2.49. Mode.Parameter.Monitoring.Temp.Status ON, OFF
Mode.Parameter.Monitoring.Temp.LowLim -170.0...500.0
Mode.Parameter.Monitoring.Temp.UpLim -170.0...500.0
Mode.Parameter.Monitoring.Temp.Action end, hold, wait, none
Parameters for STAT, DOS, DOC: Monitoring of the limit values of the tem-
perature in °C. Temperature values are entered in the list of measured points
only if the monitoring is active.
On limit value violation, an action can be selected:
end: Abort of the determination.
hold: Interrupt dosing until the sequence is continued by manual switching
(&m $C).
wait: Interrupt dosing until the limit value is no longer violated, then continue
automatically.
3.2.2.50. Mode.Parameter.Monitoring.L10Output.AssignOutput
meas, temp, rate, all, none
Mode.Parameter.Monitoring.L10Output.Limit upper,lower,any
Mode.Parameter.Monitoring.L10Output.Output active, pulse
Parameters for STAT, DOS, DOC: Output of a signal on L10 output (pin 8) of
the remote socket on limit value violation.