Metrohm 799 GPT Titrino User Manual
Page 113
3.1 General rules
799 GPT Titrino
109
$G .Mode.DOC...
As STAT.
$G .Mode.MEAS .Inac:
Instrument at the beginning or at the end of a titration.
.Req .Id1:
Instrument in the MEAS mode, requesting Id1 after start.
.Id2:
Instrument in the MEAS mode, requesting Id2 after start.
.Id3:
Instrument in the MEAS mode, requesting Id3 after start.
.Smpl:
Instrument in the MEAS mode, requesting sample size after start.
.Unit:
Instrument in the MEAS mode, requesting unit of sample size after start.
.Meas:
Instrument in the MEAS mode, measuring.
$G .Mode.CAL .Inac:
Instrument at the beginning or at the end of a calibration
.Req.Temp:
Instrument in the CAL mode, requesting calibration temperature.
.Meas.Temp:
Instrument in the CAL mode, measuring calibration temperature.
.Req.Buf1:
Instrument in the CAL mode, requesting pH of buffer 1.
.Meas.Buf1:
Instrument in the CAL mode, measures buffer 1.
.Req.Buf2:
Instrument in the CAL mode, requesting pH of buffer 2.
.Meas.Buf2:
Instrument in the CAL mode, measures buffer 2.
etc.
$G .Assembly.Bur .Fill:
Buret in filling process
.ModeDis:
Buret in DIS mode
$G .Prep.X.Active:
Preparing buret X, X=0, 1, 2.
.Empty.X.Active:
Emptying buret X, X=1, 2.
In TIP, its global status as well as the step number (X) is available.
$G .TIP.X
.Inac:
Instrument at the beginning or at the end of a TIP.
.Req .Id1:
Instrument in the TIP mode, requesting Id1 after start.
.Id2:
Instrument in the TIP mode, requesting Id2 after start.
.Id3:
Instrument in the TIP mode, requesting Id3 after start.
.Smpl:
Instrument in the TIP mode, requesting sample size after start.
.Unit:
Instrument in the TIP mode, requesting unit of sample size after start.
.Pause:
Instrument in the TIP mode, in pause.
.Info:
Instrument in the TIP mode, in info.
.Mode...:
Instrument in the TIP mode, working off a submethod. The detailed
status messages of the submethod appear, see above.
Status conditions of the global $H:
The status message of the action which has been held appears.
If the process is held because a monitored limit has been violated, its status
message is $H.Mode.XXX.Titr.
Status conditions of the global $C:
The status conditions of the global $C are identical with the ones of the global
status $G. They appear when the process has been restarted actively from the
status "Hold" ($C, key
error).