Metrohm 799 GPT Titrino User Manual
Page 151
3.2 Remote control commands
799 GPT Titrino
147
OFF means that the criterion is not monitored.
3.2.2.21. Mode.Parameter.StopCond.MeasStop pH:
0...±20.00, OFF
U:
0...
±2000, OFF
I:
0...200.0, OFF
Mode.Parameter.StopCond.UnitMStop read
only
Parameters for DET and MET: Stop when a measured value is reached. Entry
as pH value, in mV (with U and Ipol) and in uA (with Upol). The appropriate
unit can be viewed with .UnitMStop.
OFF means that the criterion is not monitored.
3.2.2.22. Mode.Parameter.StopCond.EPStop 1...9, OFF
Parameters for DET and MET: Stop when a certain number of EP's has been
found.
OFF means that the criterion is not monitored.
3.2.2.23. Mode.Parameter.StopCond.FillRate 0.01...150, max.
Parameters for DET, MET, SET, KFT, STAT, DOS, DOC: Filling rate in the titra-
tion in mL/min. Max. means maximum possible filling rate with the Exchange
Unit in current use.
3.2.2.24. Mode.Parameter.Statistics.Status ON, OFF
Mode.Parameter.Statistics.MeanN
2...20
Mode.Parameter.Statistics.ResTab.Selected original, delete n,
delete
all
Mode.Parameter.Statistics.ResTab.DelN
1...20
Entries for the statistics calculations.
.Status:
On/off switching. Requirement for statistics calculations is a valid
assignment, see 3.2.2.9.
.MeanN: Number of individual results for statistics calculations.
.ResTab.Select: Selection of the table for the statistics calculations.
original: Original table. The original table is (again) set up, i.e. any
individual results which have been deleted are reincorporated
in the statistics calculations.
delete n: Single result lines are removed from the statistics calcu-
lation. All results of the corresponding line in the statistics
table are deleted. Specification of the line number in
.ResTab.DelN.
delete all: Clear entire statistics table. The results can not be reac-
tivated.
.ResTab.DelN: Specification of the line number to be deleted.
3.2.2.25. Mode.Parameter.Evaluation.EPC DET:
0...5...200
MET
pH:
0.1...0.50...9.99
U,
Ipol:
1...30...999
Upol:
0.1...2...99.9
Mode.Parameter.Evaluation.Recognition.Selected
all, greatest,
last, window, OFF