Rockwell Automation 2098-IPD-xxx Ultra5000 Intelligent Positioning Drives Installation Manual - Manual (Page 147)

1
Publication 2098-IN001E-EN-P — April 2002
Appendix
D
Wiring Three Phase Power to a Single Phase
Ultra5000
Objectives
This appendix discusses connecting single phase Ultra5000 drives to a
star (Y) connected three phase power source. The three main aspects
of installation are:
• Mandatory Neutral Connection of Isolation Transformer
• Three Phase Line Filtering Requirements for EMC
• Voiding of CE Compliance
Applicable Drives
This appendix applies to the following Ultra5000 drives:
ATTENTION
!
The three phase isolation transformer and neutral in
line filter applications described in this document
have not been tested for EMC by Rockwell
Automation, and products used in such installations
are not considered CE marked by Rockwell
Automation.
If this three phase isolation transformer and neutral
in line filter application is used, the responsibility for
EMC validation lies with the user and CE marking of
the system becomes the user's responsibility.
If CE compliance is a customer requirement, single
phase line filters which have been tested by
Rockwell and specified for the product should be
used.
Refer to AC Line Filters on page C-3 .
• 2098-IPD-005 • 2098-IPD-005-DN
• 2098-IPD-010 • 2098-IPD-010-DN
• 2098-IPD-020 • 2098-IPD-020-DN
• 2098-IPD-030 • 2098-IPD-030-DN