MTS Model FlexTest SE - Manual (Page 66)

Models FlexTest® IIm/GT/SE Controller Hardware
Analog Chassis Transition Modules
Installation 66
Analog Chassis Transition Modules
Transition modules located on the Model 497.01Rear Panel provide signal
transfer between the Model 497 modules and external devices. One digital
transition module and up to eight analog transition modules can be installed in
this chassis. Each transition module plugs into the backplane connectors and
connects to two chassis slot locations.
How To Install a Transition Module
1. To install a transition module, remove the appropriate panel cover from the
analog chassis.
2. Plug the transition modules into the backplane connectors. Refer the
following table for transition module slot assignments.
3. Replace the panel cover and fasten the screw locks on all D connectors.
J1602 J1502 J1402 J1302 J1202 J1102 J1002 J902 J802 J702 J602 J502 J402 J302 J202 J102
System
J1601
J1501 J1401 J1301 J1201 J1101 J1001 J901 J801 J701 J601 J501 J401 J301 J201 J101
J38
Aux J28
I/O J37
Aux J27
I/O J36
Aux J26
I/O J35
Aux J25
I/O J34
Aux J24
I/O J33
Aux J23
I/O J32
Aux J22
I/O J31
Aux J21
I/O J41
Com In J42
Com Out
J43
XPTR In J51
Intlk In J50
DC Pwr
J44
XPTROut J52
IntlkOut
16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 A B
Chassis Slot Number
Analog Transition Modules Digital Transition
Modules
Transition modules in the rear panel chassis
Slot Assignment
M ODULE T YPE S LOT A SSIGNMENT
Analog Transition 1–2, 3–4, 5–6, 7–8, 9–10, 11–12, 13–14, 15-16
Digital Transition A–B