MTS Model FlexTest SE - Manual (Page 168)

Models FlexTest® IIm/GT/SE Controller Hardware
Cabling for External Command Inputs
FlexTest GT Controller Connections 168
Cabling for External Command Inputs
Cabled properly, Model 793 Controllers can receive programming from an
external controller.
How to Enable and Run External Command Inputs
1. Cable the controllers.
Cable the external programmer analog out connector to a Model 493.75
Analog In module BNC connector.
2. Allocate external command resources in Station Builder.
Using Station Builder, allocate controller resources to receive programming
from an external controller.
3. Adjust the command signal with Station Manager.
4. Start the External Command.
External Analog Source
From
I/O Carrier
Module
FS 0 t
FS
0 t
0 t
Select Waveform
Generator
410.81
Function
Control Mode Output Mode Output
Remote Local
Local Single Cycle Local Start
Finish Cycle & Stop Ret to Zero
Trigger Manual Bkpt Hold Main Sync
Output to 0
+100% FS
+100% FS
Breakpt
5 - 05%
Full Scale
Hold Time (sec)
Frequency (Hz)
Ramp Time 1 (sec) Ramp Time 2 (sec)
FS
0 Normal
Invert