MTS Model FlexTest SE - Manual (Page 39)

Connecting Electrical Power
Models FlexTest® IIm/GT/SE Controller Hardware Installation 39
Note Local electrical codes supersede any information found here.
Grounding
The chassis will not function correctly if it is not grounded as shown. Be sure
your power source is also properly grounded. The chassis includes two grounds:
a chassis ground and a signal ground. The two grounding lugs are connected
together with an external shorting bar when the chassis is manufactured.
• For the console configuration, remove the shorting bar from the ground lugs
and connect the chassis ground to the console rail.
• For a stand-alone configuration, always connect the shorting wire to both
ground lugs.
AC grounding
The AC power ground is through the power cord. The power cord must be
plugged into both the chassis and the power source for proper grounding.
Signal
Ground
Chassis
Ground
Chassis
ground is connected
through the power cord
connector.
System ground cable
(PN 039-709-2xx)
connected to other
components.
Chassis ground cable
(PN 037-766-102)
connected to the vertical
conductive rail.
System ground cable
(PN 005-402-3xx) connected
to the load frame or other
components.
Signal common cable
(PN 037-766-101)
connected to the power
panel.
Stand-alone
Configuration
Console
Configuration