MTS Model FlexTest SE - Manual (Page 246)

Models FlexTest® IIm/GT/SE Controller Hardware
Model 493.02 Chassis Multiple Controller
Hydraulic Configurations 246
Model 493.02 Chassis Multiple Controller Interconnections
FlexTest SE Controllers support the following hydraulic interconnections for
multiple controller configurations:
• Independent HSM control with no HPU
• Independent HSM control with a shared HPU
• Shared HSM with an HPU
• Shared HSM without HPU
• Independent HSM controlled with a shared HPU using first-on-last-off
For more detailed information about multiple controller configurations,
see
“Multiple Controller Connections” on page 220 and the FlexTest SE User
Manual.
Independent HSM (no HPU)
For this multiple controller configuration:
• Each controller has an independent hydraulic service manifold (HSM).
• No hydraulic power unit (HPU) is connected.
• Select HSM Only for Power Type on each connected controller.
Path: Config > Edit Hardware > Power Options > Power Type > HSM
Only
FlexTest SE
Emergency Stop
7 8 9
6
5 4
3 2 1
. 0 +/-
enter
cancel
FG Setup
Status Scope
Meters Tuning
Config Limits
Log Menu ?
A B Recall
Enabled reset
Rewind Run Hold Stop
Power
Program Hydraulic Interlock Program Interlock
HPU
HSM
Off Low High
Off Low High Navigate Monitor 1 Monitor 2
FlexTest SE
Emergency Stop
7 8 9
6
5 4
3 2 1
. 0 +/-
enter
cancel
FG
Setup Status
Scope Meters
Tuning Config
Limits Log Menu ?
A B Recall
Enabled reset
Rewind Run Hold Stop
Power
Program Hydraulic Interlock Program Interlock
HPU
HSM
Off Low High
Off Low High Navigate Monitor 1 Monitor 2
Power Type = HSM Only Power Type = HSM Only
Interlock/Hydraulics
HSM 1
056-126-4xx
J28 HSM
HSM 2
056-126-4xx
J28 HSM
056-316-0xx