MTS Model FlexTest SE - Manual (Page 38)

Models FlexTest® IIm/GT/SE Controller Hardware
Connecting Electrical Power
Installation 38
Stand-alone
installation
The stand-alone chassis can be placed on the floor. The chassis location is limited
only by the length of the system cables. The front panel of the chassis can be
removed to access the VMEbus plug-in modules.
Console installation
The rack-mounted chassis can be installed in any Model 490.8x console. Install
the console with the 493.10 Rack Mounting kit (056-139-502 for FlexTest GT).
The Rack Mounting kit provides the hardware (L-shaped brackets) to support the
chassis and mounting screws to secure the chassis to the console rack.
Connecting Electrical Power
Electrical connections must be made by qualified personnel and conform to local
codes and regulations. An electrical service panel to provide the electrical power
feed (line voltage) to the chassis is not necessary, but may be required by local
electrical codes.