MTS Model FlexTest SE - Manual (Page 150)

Models FlexTest® IIm/GT/SE Controller Hardware
Service Connections
FlexTest GT Controller Connections 150
I/O Carrier service The J3 Service connector on the Model 493.40 I/O Carrier module provides the
monitor output from each of the four I/O option cards installed. It is an 8-pin RJ-
45 connector.
Important The signals at the J3 Service connector are provided for service
and troubleshooting only. These signals are defined by the I/O
option mezzanine cards that are installed on a respective Model
493.40 I/O Carrier module. Some of these signals may be
uncalibrated. Before use, take appropriate steps to determine the
characteristics of these signals.
To
External
Device
1
2
3
4
5
6
7
8
J3
From
Daughter
Boards
Slot 1 Monitor
Slot 1 Ground
Slot 2 Monitor
Slot 2 Ground
Slot 3 Monitor
Slot 3 Ground
Slot 4 Monitor
Slot 4 Ground