MTS Model FlexTest SE User Manual
Page 261
Models FlexTest® IIm/GT/SE Controller Hardware
Index
261
power
UPS requirements
power cabling
power connections
493.10 chassis
pressure control
programming
Eurotherm temperature controller
receiving from external controllers
sending to external controllers
R
readout channel, creating
readout devices, using external
readout signal, adjust
rear-panel connectors
497.01 analog chassis
497.05 hydraulic control panel
remote station controller
.hwi file
serial interface connection
(J50)
serial interface connection (J50)
S
scope
connecting external
sensor
analog chassis connection
assigning with transducer ID
cables
sensor cables
4/8 wire jumpers
active guard jumper
part numbers
specifications
with ID module
without ID module
serial communications, cabling
service connections
J3 Service (I/O carrier)
J39 power monitor
servovalve
analog chassis connection
I/O carrier cable specifications
I/O carrier connection
shunt calibration
I/O carrier connector
shunt resistor connector
specifications
493.10 chassis
sensor cables
UPS
stand alone configuration
standard configurations, FlexTest IIm Controller
station connections
station signals
available for monitoring
descriptions
external readout of
system cables
analog I/O
part number list
servovalve cables
system cables/jumpers
System I/O module connections
T
temperature controllers, connecting. See transition modules
Temposonics sensors
connections
daughter boards
jumper configurations
test processor (498.22)
about
transducer cables
part numbers
specifications
transducer ID module
assigning a sensor
transition bus
transition module connections (analog chassis)
transition modules
analog chassis (497.01)
transition panels
description
installing
U
UPS
493.73 connections,493.73 HPU Interface board
UPS connections
FlexTest 40, FlexTest SE
FlexTest 60, 100, 200, GT
FlexTest SE, 493.42 connections
specifications