MTS Model FlexTest SE - Manual (Page 24)

Models FlexTest® IIm/GT/SE Controller Hardware
Specifications
Introduction 24
FlexTest SE Controllers
The MTS Model 493.02 FlexTest SE Controller is a fully digital Proportional,
Integral, Derivative, Feedforward (PIDF) servocontroller. It provides complete
control of one servohydraulic channel or station in an MTS test system.
FlexTest SE Controller
The FlexTest SE may be operated in the standalone mode from its front panel
controls, or in the automated mode with MTS Model 793.00 System Software
running on a connected PC.
FlexTest SE front panel
controls
Operations are controlled through the controller’s front panel. An easy-to-read
color display shows the status of the parameter currently being adjusted or
monitored. A simple scroll-through menu provides quick access to any parameter
or function. All parameters are entered through a keypad or adjusted by a single
multi-turn dial. The current settings are saved in a flash disk and are recalled at
start up.
In addition to providing the means to adjust and monitor the test parameters, the
front panel also provides program control, system hydraulic pressure control, and
an Emergency Stop button that shuts down the system hydraulics in an
emergency situation. BNC monitor connectors are also provided to allow you to
connect easily to external readout devices.
FlexTest SE Front Panel
FlexTest SE
Emergency Stop
7 8 9
6 5 4
3 2 1
. 0 +/-
enter
cancel
FG
Setup
Status
Scope
Meters
Tuning
Config
Limits
Log
Menu ?
A
B
Recall
Enabled
reset
Rewind Run Hold Stop
Power
Program
Hydraulic
Interlock
Program Interlock
HPU
HSM
Off Low High
Off Low High
Navigate Monitor 1 Monitor 2
TS-G436