MTS Model FlexTest SE - Manual (Page 228)

Models FlexTest® IIm/GT/SE Controller Hardware
Encoder Connections
FlexTest SE Controller Connections 228
D/A connections Digital-to-analog mezzanine cards support up to six program or readout signals
to external devices.
• Each D/A signal is an analog output within ±10 volts.
• Each readout signal is from a 16 bit digital to analog converter.
• Each output is a ±10 V analog output.
Cable specification
The cable specifications apply to both the analog inputs and analog outputs.
The cable from the front panel of the I/O Carrier module has the following
specification:
• 15 contact type D male EMI connector.
• Backshell–EMI metallized plastic.
• Cable type–up to 6 shielded twisted pairs, each with the drain wire
connected to the signal source.
Encoder Connections
See “Encoder Connections” on page 121.
+
-
+
-
+
-
Output 1
Output 2
Output 3
Output 4
Output 5
Output 6
+
-
+
-
+
-
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
J4 - J7
From
D/A
To
External
Device