MTS Model FlexTest SE - Manual (Page 49)

Installing the Plug-in Modules
Models FlexTest® IIm/GT/SE Controller Hardware Installation 49
Installing the 493.02 Chassis (FlexTest SE)
This section describes how to install the MTS FlexTest 493.02 chassis and
connect it to your system components.
Contents Installing the Plug-in Modules 42
VMEbus Modules 50
Chassis Installation Options 51
Connecting Electrical Power 53
Installing the Handle Kit 58
Installing the Plug-in Modules
This section describes how to install the plug-in modules into the chassis. The
modules plug into a backplane connector and are secured to the chassis with a
screw at the top and bottom of the faceplate.
The plug-in modules contain static-sensitive components.
Improper handling of the module can cause component damage.
Be sure to follow these precautions when handling modules:
• Turn off electrical power before installing or removing a module.
• Use a static ground strap to ground yourself to the chassis ground
before touching the chassis or a module.
• Keep unused modules in conductive bags. Also be sure you are
grounded when removing a module from a conductive bag.
• Handle modules with their front panel or circuit card edges. Do not
touch any circuit card components, pins, or circuit connection points.
CAUTION