MTS Model FlexTest SE - Manual (Page 239)

Eurotherm Temperature Controller Connection
Models FlexTest® IIm/GT/SE Controller Hardware FlexTest SE Controller Connections 239
Eurotherm Temperature Controller Connection
Automated FlexTest SE Controllers can program and control a single Eurotherm
temperature controller.
Note Stand-alone FlexTest SE Controllers are not equipped for use with
temperature controllers.
To use a temperature controller with a FlexTest SE Controller:
1. Configure the FlexTest SE Controller’s Debug Serial Port.
2. Cable the temperature controller to the FlexTest SE Controller.
3. Add a temperature controller resource to the hardware interface file (hwi).
4. Add a temperature control channel to the station configuration file.
Configuring the Debug
Serial Port
To use a FlexTest SE Controller with a temperature controller, configure the
Debug Serial Port as follows:
1. Access the Model 498.96 Processor circuit card in the Controller’s chassis.
2. Locate switch S3.
3. Set bit 8 to the off (open) position.