MTS Model FlexTest SE - Manual (Page 51)

Chassis Installation Options
Models FlexTest® IIm/GT/SE Controller Hardware Installation 51
Chassis Installation Options
The chassis can be fitted with the optional handle kit for table-top use in the
stand-alone configuration (shown below), and for the automated configuration it
can be installed without the handle-kit in a standard MTS equipment rack.
Note For information about installing the optional handle kit, see page 58 .
Model 493.40 I/O Carrier Mezzanine Cards
M ODEL M ODULE N AME F UNCTION
493.14 Valve Driver Produces the control signal for a Series 252 Servovalve.
493.15 3–Stage Valve Driver Produces the control signal for a Series 256 or 257
Servovalve.
493.25 Universal Conditioner Processes the signals from either an AC or DC-type sensors.
493.45 A/D Converts up to six external analog signals to digital signals for
use by the controller.
493.46 D/A Converts up to six internal digital signals to analog signals for
use by external devices.
493.47 Encoder Processes the signals from an encoder or a Temposonics III
transducer with an SSI interface.
FlexTest SE
Emergency Stop
7 8 9
6 5 4
3 2 1
. 0 +/-
enter
cancel
FG
Setup
Status
Scope
Meters
Tuning
Config
Limits
Log
Menu ?
A
B
Recall
Enabled
reset
Rewind Run Hold Stop
Power
Program
Hydraulic
Interlock
Program Interlock
HPU
HSM
Off Low High
Off Low High
Navigate Monitor 1 Monitor 2
TS-G436
FlexTest SE
Emergency Stop
7 8 9
6 5 4
3 2 1
. 0 +/-
enter
cancel
FG
Setup
Status
Scope
Meters
Tuning
Config
Limits
Log
Menu ?
A
B
Recall
Enabled
reset
Rewind Run Hold Stop
Power
Program
Hydraulic Interlock
Program
Interlock
HPU
HSM
Off Low High
Off Low High
Navigate Monitor 1 Monitor 2
TS-G436
FlexTest SE
Controller
with optional
handle kit