MTS Model FlexTest SE - Manual (Page 123)

Remote Setpoint Adjust Connections
Models FlexTest® IIm/GT/SE Controller Hardware FlexTest GT Controller Connections 123
Remote Setpoint Adjust Connections
A Remote Setpoint Adjust (RSA) control is an optional, stand-alone hardware
device that uses an incremental or absolute encoder to control actuator setpoints.
Each RSA control pod requires installation of a Model 493.47 Encoder Interface
mezzanine card on the Model 493.40 I/O Carrier board. The I/O Carrier
connector is based on the location of the mezzanine card installed on the board of
the I/O Carrier module.
For more information, see “Setting Up the Remote Setpoint Adjust” in the MTS
793 Control Software manual.
Remote Setpoint Pod
100-051-058
J6 I/O
J7 I/O
493.40
I/O Carrier
J3 Service
Shunt Cal
J4 I/O
J5 I/O
m