MTS Model FlexTest SE - Manual (Page 125)

ADDA II Connections
Models FlexTest® IIm/GT/SE Controller Hardware FlexTest GT Controller Connections 125
ADDA II Module I/O
connections
The Model 493.55 A/D, Model 493.57 DSPAD, and Model 493.56 D/A
mezzanine cards are installed in the Model 493.50 ADD II module assembly. A
connection from the front panel connector to a rear panel BNC transition module
allows easy access to the analog channels.
Note The external analog source can be a stand-alone function generator,
another controller, or a computer controlled analog output.
External Analog Source
Front Rear
493.10 Chassis
Analog Monitor
Front/Rear Cable Conduit
Daughter
Board 1
Daughter
Board 2
Daughter
Board 4
Daughter
Board 3
FS 0 t
FS 0 t
0 t
Select Waveform
Generator
410.81 Function
Control Mode Output Mode Output
Remote Local
Local Single Cycle Local Start
Finish Cycle & Stop Ret to Zero
Trigger Manual Bkpt Hold Main Sync
Output to 0
+100% FS
+100% FS
Breakpt
5 - 05%
Full Scale
Hold Time (sec)
Frequency (Hz)
Ramp Time 1 (sec) Ramp Time 2 (sec)
FS
0 Normal Invert