INFICON Cygnus Thin Film Deposition Controller - Manual (Page 152)

6 - 10
IP
N 07
4-
37
9-
P1
K
Cygnus Operating Manual
Figure 6-4 Voltage Selector Drum and Fuse
6.3.3 Routing XIU Cables
XUI to controller cables can be 15’ (4.6 m), 30’ (9.2 m), 50’ (15.3 m), and
100’ (30.5 m) in length. The signals traveling on this cable are both analog and
digital. It is suggested that it not be routed near areas with high levels of
electromagnetic interference, even if its length must be somewhat increased.
6.3.4 Interface Cable Fabrication and Pin-Out
It is necessary to fabricate several cables in order to interface the controller to the
deposition system. Refer to
section 6.2.3, Minimizing Noise Pickup From External
Cabling, on page 6-7 .
6.3.4.1 Source Control Connection
A Digital to Analog Converter (DAC) card, IPN 760-1112-G1, is included as
standard equipment with the controller. It provides 6 conversion channels. These 6
channels may be programmed for source control or chart recorder functions as
desired. The 6 connectors are BNC.
120 Vac