3 parameter commands, 1 all parameters, 1 query all parameters – INFICON Cygnus Thin Film Deposition Controller User Manual
Page 113
5 - 9
IP
N 07
4-
37
9-
P1
K
Cygnus Operating Manual
5.4.3 Parameter Commands
Query commands are used to request established parameter values. There is a
specific query command for each parameter group. Depending on the actual
hardware configuration, the response to some Query commands may be an "E"
error code indicating there is no data to retrieve. Each command has one to three
arguments.
Update commands are used to change a specified parameter to a new value or
condition. Some parameters are order dependent in that they cannot be updated
prior to certain other parameters. There is a specific update command for each
parameter group.
The command variations include:
5.4.3.1 All Parameters
5.4.3.1.1 Query All Parameters
Query: The message format is:
QA
Command Response:
ACK Length = 2 bytes (low byte / high byte) NOTE: This length is NOT the same as the length of the packet. It tells how many bytes follow in the data. Table 5-3 Parameter Commands QUERY command parameter UPDATE Command QA All Parameters UA QC Channel Parameters UC QG General Parameters UG QI Input Name UI QL Logic Statements UL QO Output Name UO QT Output Type UT
All Channel 1 parameters, All Channel 2 parameters,...All Channel 6
parameters.
All General Parameters
All Logic Statements
All Output Types
All Output Names
All Input Names>|