Toshiba Magnia 3310 - Manual (Page 44)

Getting Started
Removing and replacing the server panels
25
Removing and replacing the server panels
To mount optional devices inside the server, you need to remove
the side panel if your server is a pedestal model, or the top panel, if
your server is a rack model.
WARNING: Before removing or replacing a server panel,
always turn off the power of the server by unplugging all the
power cables. Failure to do so might cause you to get an
electric shock.
Before starting the job to remove and replace the rack
model's top panel, carefully read “Sliding the server out of or
in the rack” on page 62, and proceed to the job according to
the following procedure.
CAUTION: When installing or removing the server panels, be
sure to wear gloves. Otherwise, the sharp protrusions on the
server may injure your hands.
When sliding a server panel, be careful not to catch you finger
between it and the server. The panel might cause injury.
NOTE: The rack model’s top panel corresponds to a pedestal
model’s side panel.
Removing the side panel (for pedestal model)
Follow these steps to remove a side panel:
1 Shut down the server and turn off the power button if it is in
operation.
2 Unplug all the power cables.