Toshiba Magnia 3310 User Manual
Page 193
Installing Software
Windows Server® 2003
176
Server Setup TooL, onto the floppy disk drive, and then press
the
4 When the following message appears, select “Adaptec
Ultra320 SCSI Card (Win XP/Server 2003 IA32)” and then
press the
If there are no other SCSI drivers to be added, then continue to
install Windows Server 2003, following the instructions that
appear on the screen.
Procedure after installation of the Windows Server 2003 Server
After the installation of the Windows Server 2003 is complete,
follow the procedure mentioned below:
Changing the Bootup Order
Use the BIOS setup utility to return boot sequence order to the
default. Press <-> to move “CD-ROM Drive” to a lower order
in the boot sequence than “+Hard Drive”.
See “Changing the boot sequence” on page 181.
Setting up the Physical Address Extension
When more than 4 GB of system memory is mounted on this
server and you run Windows Server 2003 Enterprise Edition,
use the following settings to enable memory capacity greater
than 4 GB.(If mounted memory is 4GB or less, this setting
need not be made.) To enable this setting, restart the server.
1 Start Windows Server 2003 Enterprise Edition, and log onto
Windows Server 2003 Enterprise Edition as the Administra-
tor(or a user having equivalent rights).
2 Select “Start” - “Run...” and execute the following to activate
the “Notepad”:
notepad c:\boot.ini
Adaptec Ultra320 SCSI Card (Win XP/Server 2003 IA32)