Toshiba Magnia 3310 - Manual (Page 219)

Troubleshooting
Troubleshooting
203
1 Are the CPU, memory, and keyboard properly connected?
See “Installing and Removing Hardware” on page 56.
2 Start up the BIOS Setup Utility to check the BIOS setup.
See “BIOS setup utility” on page 148.
Loading of RAID controller BIOS stops midway
Probable causes are that the RAID controller and hard disk drive
are not properly connected, or that the RAID configuration is
damaged or not built. Carry out the following procedure to check
the cause of the trouble.
If this does not remedy the problem, turn off the power first, and
then proceed to “Remedy When Windows Server 2003/ Windows
2000 is unusable” on page 210.
1 Is the RAID controller properly connected?
See “Expansion cards” on page 129.
See the operating manual of the RAID controller.
2 Is the Hard Disk Drive (HDD) properly connected?
See “Hard Disk Drive (HDD)” on page 121.
3 Execute the RAID controller utility to rebuild RAID.
All data may be lost if RAID is rebuilt. Do not rebuild RAID if
rebuilding is judged to be difficult.
See the operating manual of the RAID controller.
Cannot install the OS
A probable cause is that the hard disk drive is not recognised.
Carry out the following procedure to check the cause of the
trouble.
If this does not remedy the problem, turn off the power first, and
then proceed to “Remedy When Windows Server 2003/ Windows
2000 is unusable” on page 210.