Toshiba Magnia 3310 - Manual (Page 131)

Installing and Removing Hardware
SCSI device
113
SCSI device
The installation of a SCSI device requires special knowledge or
technology. If you have no experience in installing a SCSI device,
or find installation difficult, consult your authorized MAGNIA
service provider. (Service is provided for a fee.)
Up to maximum two SCSI bus-compatible SCSI devices can be
installed in device bays.
NOTE: Wide cables are connected with the onboard SCSI
controllers of this system. Therefore, an optionally-available
SCSI conversion connector is needed to connect a SCSI
device with a narrow connector. When connecting some
SCSI devices to this system, it is necessary to change their
settings.
See the accompanying manual for each SCSI device.
SCSI ID
The server has two built-in onboard SCSI controllers. Only
internal hard disk drives can be connected to the onboard SCSI
controller on channel A, and only SCSI devices installed in the
5.25" device bay can be connected to the onboard SCSI controller
on channel B.
The SCSI ID of the SCSI device to be installed in device bays is
set so that it does not overlap with the SCSI ID of other devices
installed in channel B.
NOTE: The SCSI IDs of the SCSI device installed and the
internal hard disk drive can overlap because the connected
SCSI controller differs.