Toshiba Magnia 3310 - Manual (Page 132)

Installing and Removing Hardware
SCSI device 114
The channel SCSI ID of the previously installed device is as
follows:
To confirm and change the setting of the onboard SCSI
controllers,
See “Onboard SCSI utility” on page 164.
Detecting the hard disk devices (SAF-TE)
This system complies with SAF-TE, and therefore it transfers the
following information on the hard disk devices to the RAID
controller.
™ Detection of device presence
™ Status of a drive slot for insertion and removal.
™ Notification of the occurrence of a failure
(by lighting up the disk status indicator)
Terminator
The SCSI bus on channel A is terminated at the on board SCSI
controller and disk chassis. The SCSI bus on channel B is
terminated at the on board SCSI controller and dedicated SCSI
cable.
Removing the device bay spacer
The device bay spacer is used to keep dust and dirt out of the
Device bay.
Remove the device bay spacer in the procedure described below,
after referring to “Before starting operation” on page 57:
SCSI device Channel A Ultra320 Wide
(68 pins)
Channel B Ultra320 Wide
(68 pins)
SCSI controller 7 7
SAF-TE controller 6
HDD 0 - 5