Toshiba Magnia 3310 - Manual (Page 185)

System Configuration Setup
Onboard SCSI utility
167
Device setting
If you select “Configure/View SCSI Controller Settings” in the
main menu screen in the device setup mode, the following screen
is displayed.
SCSI Controller ID :7
Set the SCSI ID of the onboard SCSI controller. Do not change
the setting value.
SCSI Controller Parity: Enabled
Set whether or not to perform a parity check and a scan when
the onboard SCSI controller transfers regular data over the
SCSI bus.
SCSI Controller Termination: Enabled
Set whether or not to set the onboard SCSI controller as the ter-
minator on the SCSI bus.
Do not change the setting value.
Adaptec SCSISelect( TM ) Utility vX.XX
AIC-7902 X at slot XX, XX:XX:XX
Configuration
SCSI Bus Interface Definitions
SCSI Controller ID ....................7
SCSI Controller Parity ................Enabled
SCSI Controller Termination ...........Enabled
Additional Options
Boot Device Configuration .............Press
SCSI Device Configuration .............Press
Advanced Configuration ................Press
- Reset to SCSI Controller Defaults
BIOS Information
Interrupt (IRQ) Channel ...............XX
I/O Port Address ......................XXXXh
Arrow keys to move cursor, to select option, to exit (**default)